Datalogic PowerScan RF Programming Manual page 150

Label Length
Format
Variable
Length
Format
144
Follow the steps below to set the MSI/Plessey label length format to
either the Variable Length or Fixed Length format.
Follow the steps below to set the MSI/Plessey to read Variable Length
Format.
1. Identify the minimum length setting you want to make. The
selectable range is 04 to 16 characters.
2. Scan the SET bar code.
3. Scan the ENABLE VARIABLE LENGTH FORMAT bar code.
4. Scan the SET MINIMUM LABEL LENGTH bar code.
5. Set the minimum label length by scanning the applicable digits
bar codes on page 147, then return to this page.
If you are setting a label length less than ten, you
must scan a zero digit first and then the length
digit (e.g., 04, 06, 08).
NOTE
6. Scan the END bar code.
Variable Length
SET ------------------------------------------
Enable Variable Length
Format
Set Minimum Label
Length
END ------------------------------------------
---------
---------
PowerScan
®
RF Scanner