Datalogic PowerScan RF Programming Manual page 211

SPEAKER
INDICATION
Six beeps consisting of 20 ms
Scanner Not
on, 20 ms off
Currently
Linked
100 ms on (short)
250 ms on (medium)
Good Read
Beep
500 ms on (long)
20 ms on
Partial Read
Bip
100 ms on (short)
Base Station
250 ms on (medium)
Acknowledge-
ment Beep
500 ms on (long)
High, then low, then high, then
low.
Transmission
Error Beep
Low, then medium, then high.
Link Beep
High, then medium, then low.
Unlink Beep
RF Programming Manual
Table 11. Scanner BEEPER Functions
DURATION COMMENT
Indicates a bar code was read before the scanner was
linked to a Base Station.
Three programmable functions are available. This indi-
cates a bar code has been read and decoded.
A very short beep ("bip") is sounded when one bar
code of a two-bar code pair has been successfully
decoded.
Indicates a successful bar code transmission to the
host (configurable), a successful change of channel, or
a successful transmission of a new configuration to the
host.
Indicates unsuccessful transmission to the host.
Indicates a scanner has been successfully linked to a
base station.
Indicates a scanner has been successfully unlinked
from a base station.
205