Wait Time For
Scanner Power
Shutdown
166
Feature is specific to scanner ONLY
To conserve battery life, the handheld scanner can be automatically
shut down when it has not been in use for a given period. A trigger
pull or other stimulus will then be required to reactivate the scanner.
The idle duration determines how long the scanner stays on/active
after each use. Range for this feature is a setting of 1 to 120 seconds in
one-second increments. A setting of one second is recommended.
Selecting higher values for this feature will effect
the length of battery life.
NOTE
SET -------------------------------------------
Set Wait Time for Scanner
Power Shutdown
Scan three digits representing the desired delay using the Num-
ber Pad in Appendix C: Keypad. Be sure the number is padded
with leading zeros (example: 001 = 1 second, 025 = 25 seconds,
100 = 100 seconds, etc.), then scan the END bar code.
END ------------------------------------------
---------
PowerScan
®
RF Scanner