Where To Go From Here - Datalogic PowerScan RF Programming Manual

Where To Go From Here

18
Programming is easy and straightforward if you follow these steps:
If you are changing some interface types (for exam-
ple; if you are moving the RF unit from a Universal
Keyboard Wedge to an RS-232 host) you must first
change the hardware. Replace the Base Station's
interface board (if required) and connect to the host
terminal using the new interface cable BEFORE
NOTE
performing any programming changes. See Hard-
ware on page 4 for more information.
1. If you are changing the unit's interface type, follow the instruc-
tions in the section titled, Changing Interfaces on page 4 before
proceeding.
2. Scan any feature bar codes that are unique to the interface you
are currently programming.
3. Turn to Symbologies Supported on page 73 if you are going to
change any bar code symbologies or modify any symbology-
related features.
4. Turn to the section, General Features if you wish to change or
modify any of the scanner's other features.
Once the necessary changes have been made, and you have scanned
the END bar code, you are ready to scan.
®
PowerScan RF Scanner