Rf Beeper Settings - Datalogic PowerScan RF Programming Manual

If the Scanner
Fails to Link
with the Base
Station
RF Beeper
Settings
RF Programming Manual
Here are reasons why your scanner may not be linked with the Base
Station:
• There may be too many scanners attempting a link with the
same Base Station. A maximum of eight scanners may link
with one Base Station at a given time. Reference the section, Set
Maximum Linked Scanners for more information.
The limit imposed for linked scanners is selectable
to either: 1) disallow any new, additional scanner to
be linked beyond the set limit (this is the default), or
2) drop the link with the scanner least recently used.
Be aware that in linking additional scanners to a
CAUTION
single Base Station, you may inadvertently unlink
another scanner from the Base Station.
Links may be dropped by the Base Station if it has been reset (power
cycled). It may be necessary to relink all scanners upon system reset.
See also, Drop Links on Reset Option.
The RF version of the scanner exhibits different beeper behavior than
standard (non-RF) models. For more information about RF beeper indi-
cations, see Appendix E: LED and Beeper Indications.
The following descriptions highlight configurable
beeper functions that are unique to RF handheld
scanners. All other beeper functions supported by
the standard version of the scanner are supported
NOTE
by RF models.
Good Read Beep — When good read beep is enabled, this beep sounds
at the time the scanner successfully reads a bar code. Selectable settings
for the good read beep include:
• RF When to Beep
• Beeper Volume
• Good Read Beep Frequency
• Beep Duration
151