Single Character Prefix Or Suffix - Datalogic PowerScan RF Programming Manual

Single
Character
Prefix or Suffix
60
5. Scan the END bar code. You have added a two character suffix
to all bar code data, regardless of label symbology, that will be
added to the label data before it is sent to the host
Setting Global Suffix(es)
SET -------------------------------
Set Suffix ---------
Turn to Appendix C: Keypad on page
to the Hex Values determined in step one above.
END ------------------------------
Transmit Scanner
Configuration to
Base Station ---------
The scanner will not transmit a prefix or suffix character if its hex value
is set to zero. To set a prefix or suffix that has only one character, follow
these steps:
1. Scan the SET bar code on page 62.
2. Scan SET PREFIX or SET SUFFIX bar code.
3. Turn to the keypad (Appendix C: Keypad on page 193) and scan
the two-digit hex code that represents your desired character
(refer to the ASCII chart on the inside back cover of this man-
ual for this conversion).
4. Scan the digit '0' two times to disable transmission of a second
character.
193, and scan the four digits corresponding
PowerScan
®
RF Scanner