Datalogic PowerScan RF Programming Manual page 67

RF Programming Manual
For example, if 'Space' (SP) is desired, the chart shows that the corre-
sponding hex code for 'SP' is 20, thus you would scan the digit 2, then
the digit 0 for the first character, followed by 00 digits from the keypad
for the second character, (e.g., scan 2,0,0,0). Return to this page and go
to step five.
NOTE
NOTE
5. Scan the END bar code on page 62.
Successful programming of a prefix or suffix
requires 4 digits.
If you make a mistake or lose your place while
setting this option, scan the END bar code to
exit Programming Mode. The scanner will
sound a two-beep error tone to indicate that
programming was incomplete, and the setting
will remain as it was before entering Program-
ming Mode.
61