Table of Contents
Advertisement
If you are on the phone when your phone rings with this setting, your phone will ring
at the lowest level.
Press FNC
Press LNR/SPD
Dial *
Dial 3
Dial either:
0 - No Ring
1 - Ring
Press FNC to store your changes
Programming Feature Access Buttons
Each NEC Ranger handset is equipped with 12 buttons with dual-colour LEDs that
can be used as either line access keys or feature access buttons in addition to an extra
4 buttons without LEDs that can be used as feature access buttons.
Programming unused LEDs for DSS, features, etc. is extremely easy.
•
With the station idle, press the FNC button
•
Press the LNR/SPD button
•
Press the desired Feature Access Button
•
Enter 1 for Direct Station Selection; 0 for Speed Dial; or # for Feature Access
•
Enter the station number, speed dial buffer number or feature access code
(depending on which mode you selected in the previous step)
•
Press the FNC button
NOTE:
1. By default the first two rows of keys are reserved as line keys and cannot be
used as feature access. To set these keys as feature access requires system
programming. Instructions on how to do this will be added soon, otherwise
contact me
for instructions if you wish to do it immediately
You can also use the Direct Station Selection mode to program feature access to
features such as paging. For example, for "All Internal", select DSS mode and then
enter "70" as the station number
11
Hide quick links:
Advertisement
Table of Contents
