Ignition Timing Check - Yamaha XC200T Service Manual

ImNsP ]
UGNmON TiMiNGCHECK ADJ
6. Check:
.. oIgnition timing
The ignition timing is adjusted for maximum
performance at the factory. DO NOT attempt
to change this setting,
ignition timing check steps:
®Connect the Timing Light (_ (YU-33277) to
the spark plug wire. ___
®Warm up the engine, and keep the engine
. running at the specified idle speed of 1,300
r/min. Use the Inductive Tachometer
(YU-08036) to check the engine speed.
oVisually check the stationary pointer (_) on
the crankcase to verify it is within the required
firing range (_) indicated on the flywheel.
Incorrect firing range-* Check flywheel and/or
pickup assembly (tightness and/or damage).
Refer to "CHAPTER 6. ELECTRICAL" for fur-
ther information.
7. Remove:
eMuffler assembly
8. Install:
oComponents in above list (step "4-1")
. 9. Tighten:
oComponents in above list (step "3 and 2")
Flange Bolt (Muffler):
25 Nm (2.5 mokg, 18 ftoib)
Socket Bolt (Exhaust Pipe)
30 Nm (3.0 m,kg, 22 ft=lb)
Bolt (Passenger Footrest):
25 Nm (2.5 m okg, 18 ftolb)
2-24