Yamaha XC200T Service Manual page 92

ENG
INSPECTION AND REPAMR
2o Remove:
@Screws (Starter wheel)
Use the #40 Torx Driver (YU_29843_7)(_1-}.
/;_-_
@Starter wheel
L_J
3. Remove:
o Rollers {i}
oSpdng caps {8}
oSprings (_
_nspeetion
1, Inspect:
(_-}._ o Roller {]i)
._) *Spring cap (2_
Spring (_)
@
@Cfutch housing _)
Deform/Wear/Damage RepJace°
....... 2. inspect:
oBushing/Roller contact surfaces (Starter
-_} clutch gear /-_ . L1/)
@ Bushing contact surfaces (Starter wheel _,})
Scratches/Heat damage/Wear-_ Replace.
@Starter cJutch gear _}
@Idle gears _!!}
@Idle gear shaft @
Scratches/Wear/Damage -o_ RepLace.
3_39