Assembly - Yamaha XC200T Service Manual

[cAoot 1 cAoouo0Too
............ 12. Inspect:
eDiaphragm
(Coasting endcher}
Damge/Torn-* Reptace_
13. Check:
oChoke unit operation
Refer to "CHAPTER 6. AUTO CHOKE UNF
TEST" section.
ASSEMBLY
To assemble the carburetors, reverse the disas_
sembty procedures. Note the following points.
e Before reassembling, wash aimparts in cmean
gasoBineo
eA_ways use a new gasket°
1. Measure:
®Float height
Out of specification-* Adjust.
FJoat Height:
26-_28 mm {1.024_- 1.102 in)
Float height measurement and adjustment
steps:
®Hotd the carburetor in an upside down po--
__ sit,on.
o Measure the distance between the mating sur-
face of the float chamber and top of the float
using a guage.
{_ Float height
NOTE;
The float arm should be resting on the needle
vatve, but not compressing the needle valve.
4-.11