Yamaha XC200T Service Manual page 156

__® HANDLEBAR AND FRONT FORK
3. Tighten:
®Ring nuts (Lower and upper}
....... Ring nuts tightening steps:
.... NOTE:
Set the Torque Wrench to the Ring Nut
Wrench so that they form a right angle.
,Tighten the lower nut (!_ using the Ring Nut
Wrench (YU_.33975} _.
Ring Nut {1-_{Bnitial Tightening}:
30 Nm (&0 mokg, 22 ftolb}
oLoosen the lower dng nut (1_ completeiy and
retighten it to specification,
Do not over-tightening.
.ot¢/ ioo, . 0.too,n0,:
.... kg, 2°2 ftolb}
o Check the front fork by turning it lock to lock.
Jf there is any binding, remove the front fork
, ........... assembly and inspect the steering boll bear-
ings and boll races.
®Hold the lower ring nut t#_!i) a nd tighten the
upper ring nut _'_ using the Ring Nut Wrench
(YU-33975) _2_o
_g, 22 ft_lb)
Shock Absorber
I. The compression arms should be installed
with the identified mark (L} (R) _ face lefb
side of scooter:
........
5q9