Yamaha XC200T Service Manual page 237

CABLE °OOT,°O
(_) Audio pilot [] Clamp the wire harness.
(_) Flasher relay Do not over-tighten it.
.. _) Horn
(_ Band [] Clamp the wire harness.
(_ Throttle cable Pull the harness as much as possible so as to
(_) Front brake switch lead take out the slack.
Handlebar switch (Right)lead
_) Audio pilot lead [] Place the wire harness, front brake switch lead,
(_ Speedometer cable and sidestand switch lead, through the cut-out
(_ Handlebar switch (Left) lead section of the inner fender.
(_) Diode unit
(_ Main switch illumination lead
(_) Main switch
(_ Headlight lead
(_ Front brake cable
(_ Front flasher light (Left) lead
(_ Wire harness
(_ Front flasher light (Right) lead
(_) Starting circuit cut-off relay
7-20