Yamaha XC200T Service Manual page 90

, sPEcT,oo Aoo O EPA,O
1o Install:
A I cOil seals (New) _
To the secondary sheaves.
_ Press-in OH Seam Depth _:
(_) _ 1.5 mm (&06 in}
2, Lightly grease the oil seal lips,
3. Apply:
eShaded areas (as a illustration _)
Lithium-Soap Base Grease
SufficientUy Coat.
_- I_] Fixed sheave
_ [_] Sliding sheave
4, Wh_d o
oAdhesive tape @
Around the shaft end of the secondary fixed
sheave _
5, Install:
oStidinq sheave _:3_
NOTE:
Be carefult so that the oil seal lips are not turned
over when installing the sliding sheave,
6. Install:
®Guide collar _
®Guide pin (.2_
eO_rings (New) _3-_
NOTE: _ _
Always use a new O-ring,
7_ Apply:
*Groove (Secondary sliding sheave) _i_
cO-rings #_
[_ Lithiumosoap Base Grease
Sufficientmy Coat,
8. Instal J:
®Spring seat
o Clutch assembly
NOTE:
3_37 Thoroughly wipe off .the excess grease,