California Instruments 2253i User Manual page 70

User Manual
4.2.9 CONFIGURATION Menu
The configuration menu may be used to con
port, IEEE-488/GPIB address, LAN settings
the supply.
ENTRY
ADDRESS
BAUD RATE
PON STATE
CONTROL
LANGUAGE
California Instruments
figure various aspects of the instrument such
(units with -LAN option only) and the power-on
DESCRIPTION
0 - 31 Sets the selected IEEE / GPIB bus address
for the optional IEEE/GPIB interface.
Factory default is address 1. The shuttle knob
or the keypad can be used
0 through 31. Do not use address 0 as this
address is typically reserved for the GPIB
controller.
9600 Sets the baud rate for the USB, RS232 and/or
19200 LAN (Ethernet) communications port. Factory
38400 default is 460800 baud. Available settings are
57600 9600 through 460800 baud.
115200 Note: For USB and LAN use, you must set
230400 the baud rate to 460800. The shuttle knob can
460800
be used to scroll through these selections.
REG0 Determined power on state. This setting
RST selects either non-volatile REG0 to be recalled
automatically at power-on or factory default
(RST). Fa
the factory settings.
Note that to use REG0 for power-on default,
the contents of the register must be
programmed first. See section 4.2.8. If an
empty register is selected, the power source
will revert back to RST (factory setting).
This is an information-only field that displays
MAST
the controller operation mode. For a single
AUX
stand-alone iX unit, the mode is always MAST
(Master).
SCPI Displays the active programming command
ABLE language syntax selection. Default for
compact i/iX series is SCPI (Standard
commands for Programmable Instruments)
the –ABL option is installed, the ABLE (Atla
Based Lan
to set a value from
ctory default is RST, which recalls
guage Extension) syntax can be
2253i / 2253iX
as the serial
settings of
. If
s
70