California Instruments 2253i User Manual page 152

User Manual
Number Message String
lost"
-315 "Configuration memory
lost"
-330 "Self-test failed"
-350 "Queue overflow"
-400 "Query error"
-410 "Query INTERRUPTED"
-420 "Query
UNTERMINATED"
-430 "Query DEADLOCKED"
-440 "Query
UNTERMINATED"
0 "No error"
40 "Voltage self test error,
output 1"
41 "Voltage self test error,
output 2"
42 "Voltage self test error,
output 3"
43 "Current self test error,
output 1"
44 "Current self test error,
output 2"
45 "Current self test error,
output 3"
403 "CAL not enabled"
801 "Output volt fault"
California Instruments
Cause
contents lost
Hardware configuration
settings lost.
Internal error
Message queue full.
Unable to complete query.
Query issued but
response not read.
Query incomplete.
Query canno t be
completed
Query incomplete .
No errors in queue
No. 1/A amplifier in M aster
source has no output
during Self-test.
No. 2/B amplifier in Master
source has no output
during Self-test. Three
phase models only.
No. 3/C amp lifier in
Master source has no
output during Self-test
Three phase models only.
No. 1/A amplifier in Aux.
Source has no output
during Self-test.
No. 2/B amplifier in Aux .
Source has no outp ut
during Self-test. Three
phase models only.
No. 3/C amplifier in Aux.
Source has no output
during Self-test. Three
phase models only.
No password entered fo r
calibration
- Output voltage does not
match program value
when ALC is on.
- Over load
- Voltage kick-back
- No ou tput voltage
Remedy
Contact CI service department at
support@calinst.com to obtain
instructions on restoring configuration
data.
Contact CI service department at
support@calinst.com
Too many m essages. Read status using
SYST:ERR query until 0, "No E
received indicating queue emp
Check programming manual for c
query format and param eters
Check application program for corr
flow. Response must be read af
query to avoid this error.
Chec k for terminator after query
command.
Check application program for multiple
queries
Check for terminator after query
command.
Contact CI service department at
support@calinst.com
Contact CI service department at
support @calinst.com
Contact CI service department at
support@calinst.com
Contact CI service department at
support@calinst.com
Contact CI service department at
support@calinst.com
Contact CI service department at
support@calinst.com
Enter correct CAL password.
Load exceeds current limit and unit is i
Constant Voltage (CV) mode of
operation.
- Reduce load or increase CL setting.
Output voltage is driven above
program med voltage by external
2253i / 2253iX
rror" is
ty.
orrect
ect
ter each
n
152