Table of Contents
Advertisement
User Manual
Fmax
h
Fmax is the upper frequency lim
Level is the percentage of the harmonic with respect to the fundamental expressed as a
fraction (e.g. 10% = 0.1)
h
is the harmonic number, e.g h
n
This value Fmax
lowest result is assigne
this specific waveform.
If Fmaxh is below the minimum frequency limit, the wavef
the label will be deleted from the waveform catalogue.
If the iX Series is used over the bus, th
t
he maximum
allowable fundamental f
as part of a program will prevent range errors.
Limits assume a program of full-scale voltage. No adjustments for voltage setting are made below the
full-scale value.
W
aveform sele
will be generated to reflect this type of error:
"22,Wave
T
ransient editing
not check for the error until transient e
4.4.5 Sw
itching Wav
eforms
W
aveform
s can be switched as part of the
F
UNC field. This field allows selection of any of the standard or custom waveforms available in
waveform memory. Refer to the section on transients for more details on using transient list to
output waveforms.
California Instruments
is th
e maximum allowable fundamental frequency that can be programmed
is evaluated for all the harmonic components in the downloaded waveform and the
h
d as the computed upper fundamental frequency limit that may be used with
requency for th
ction and frequency pro
form harmonics limit"
will also generate the above error du
it of the power source
th
is the 11
harmonic or h
11
orm will be rejected at down load time and
e ":FREQ? MAX" quer
y command can be used to determine
e selected wave
gramming will be subject to th
ring keyboard
xecution.
transient system. Each transient typ
2253i / 2253iX
= 11.
n
form. Using the returned value
e above limit. An error message
entry. Remote transient entry will
e setup menu has a
switch
82
Advertisement
Table of Contents
