Table of Contents
Advertisement
User Manual
4.2.7 TRANSIENT Menu
The transient menu is used to program and exec
se
qu
ences are defined as a se
time controlled manner.
Each step in these lists is assigned a sequ
determines the order in which each step is
Each step can control the voltage setting, voltage slew rate, frequency setting, frequency slew rate
an dwell time. The dwell tim
d
progressing to the next step. Dwell times c
Transient lists can be set up from the front
the rest of the front panel settings in one of
ENTRY
TRAN ST
COUNT
California Instruments
ute user-defined output sequences. These output
quentia
l list
of voltage and/or current settings that can
ence number ranging from #0 through #99. The
executed.
e determ
ines
how long the output dwells at the current ste
an range from 1 ms up to 900000 seconds.
panel or over the bus. The transient list can be sa
the setup registers. (See Register Menu).
DESCRIPTION
In
dicates
the
status of the transie
of operation are:
IDLE
Transient system is in IDLE or inactive state. To
start a transient list, p
on the TRAN STATE
must be ON to run a transien
error message will be display
WTRIG
Transient system is armed
trigger event.
BUSY
Transient system is active. A transient list
execution is in progress.
Sets the exec
ution count for the transient system. A count of 1
indicates the transient will run 1 time. The count value can be
set with the shuttle knob or the keypad while the cursor is on
th
is field.
The
count range is from 1 through 2E+08. Values
below 200,00
0 are displayed in fixed point notation. Value
nt system. Available modes
ress the ENTER key while
field. Note that the output
t program or an
ed.
and waiting for a
2253i / 2253iX
be executed in a
numbering
p before
ved with
66
Advertisement
Table of Contents
