Table of Contents
Advertisement
User Manual
4.3.3 Change Output Values in SET Mode
The SET mode of operation is a mode in which changes to output parameters made with the knob or
the entry keypad do not affect the output until the Enter key is pressed. The AC source is put in this
SET mode by pressing the Set key twice. A blinking cursor indicates SET mode is active.
To change the output voltage:
1. Press the Set key twice
2. Place the cursor on the VO
3. Rotate the shuttle knob clockwise to increase the value, counterclockwise to decrease the value
or enter a new value using the keypad but do not press the Enter key yet.
4. A blinking underline cursor will appear in the data for the VOLT field to indicate a change in
settings but the output remains unchange
5. Place the cursor on the FREQ entry using the down arrow key.
6. Rotate the shu
or enter a new value using the keypad but do not press the Enter key yet.
7. A blinking underline cursor will appear in the data for the FREQ field to indicate a change in
settings but the output remains unchanged.
8. Press the Enter key.
Both new voltage and frequency output v
Note that output settings such
screen as well. If all three phas
change the output voltage on all three phases. If only one phase is selected, only the output of the
selected phase will be affected.
California Instruments
LT entry
ttle knob clockwise to increase the value, counterclockwise to decrease the value
alues are now present at the output.
as voltage and frequency can be changed from the measurement
es are selected on three phase models, slewing the shuttle knob will
Counter
Clock
wise
DECR
d.
2253i / 2253iX
Clock
wise
INCR
79
Advertisement
Table of Contents
