Table of Contents
Advertisement
User Manual
10. Option -704: MIL-STD 704 Rev D & E (MIL704 Mode)
10.1 General
Option –704 includes a firmware implementation for Mil-Std 704 revision D and E and a short version
of r
evis on F. For testing to revision F conform the
i
imp
lem ntation is available. The software based a
e
Software Manual, CI P/N 4994-971, which is distributed on the same CD as this manual.
This user manual assumes that the user is familiar with the text of the relevant MIL-STD 704, test
standard. No attempt is made to explain or elaborate on the actual test specification. The–704 option
supports both AC and DC power applications.
Test Execution Considerations
Several of the MIL-STD 704 test steps take considerable time to execute. Tests in progress may be
aborted by using the BACK button on the power source front panel.
10.2 Initial
Setup
Nominal parameters for the AC Power source are as follows:
Output Voltage
Output Frequency
Nominal parameters for t
Ou
tput Voltage
Not
e: A setting outside these nominal values will disa
the 704 Menu screens or execution of any test step.
The Compa
ct i/iX Series has a maximum voltage range for 300Vrms. Consequently, not all tests for
230VAC no
minal input voltage EUT's can be performed.
10.3 Test Revision
The MIL-ST
D 704 option is capable of performing many sub-sections of MIL-STD 704 revision D or E.
A selection
is made available to specify the revision of standard to be applied to the EUT. The MIL704
option defaults to Revision E.
California Instruments
11
5V L-N or 230V L-N
360 Hz to 8
00 Hz for all revisions.
60 Hz for revision F only.
he DC Power source are as follows:
28V or 270V L-N
MIL704 handbook, the GUI based software
vionics tests are covered by a separate Avionics
ble the test and will prevent access to
2253i / 2253iX
131
Advertisement
Table of Contents
