Table of Contents
Advertisement
If the ring-indicate power-on setting is changed, you must select option 30 (Refresh
Modem Settings) to update the modem settings. If option 30 (Refresh Modem
Setting) is selected, and the modem(s) have not been configured, you will be asked
to configure the modems first. See "Call-In/Call-Out Setup Menu" on page 274 for
information on configuring modems.
Option 2 is used to set the number of rings.
Note: In order for the ring-indicate power-on settings to take effect and ring-indicate
power-on to be enabled, the service processor menus must be exited
completely. Enter 99 at the Main Menu screen to completely exit the service
processor menus.
v Reboot/Restart Policy Setup Menu
The following menu controls reboot/restart policy:
Reboot/Restart Policy Setup Menu
1. Number of reboot attempts:
Currently 1
2. Use OS-Defined restart policy?
Currently Yes
3. Enable supplemental restart policy?
Currently No
4. Call-Out before restart:
Currently Disabled
98. Return to Previous Menu
1>
Reboot is the process of bringing up the system hardware; for example, from a
system reset or power on. Restart is activating the operating system after the system
hardware is re-initialized. Restart must follow a successful reboot.
– Number of reboot attempts - If the server fails to successfully complete the boot
process, it attempts to reboot the number of times specified. Values equal to or
greater than 0 are valid. Only successive failed reboot/restart attempts are
counted.
– Use OS-Defined restart policy - Allows the service processor to react or not
react in the same way as the operating system to major system faults by reading
the setting of the operating system parameter Automatically Restart/Reboot
After a System Crash. This parameter may or may not be defined, depending on
the operating system or its version/level. If the operating system automatic restart
setting is defined, then it can be set to respond to a major fault by restarting or by
not restarting. See your operating system documentation for details on setting up
operating system automatic restarts. The default value is Yes.
Chapter 7. Using the Service Processor
263
Advertisement
Table of Contents
