IBM F80 Service Manual page 118

Table 2. Firmware Checkpoints (continued)
Checkpoint
E604
E605
E60E
E60F
E6FF
E700
E701
E702
E703
E704
E705
E706
E707
E708
100
Service Guide
Description
SSA PCI adapter BIST and
subsequent POSTs have completed
successfully.
SSA PCI adapter BIST has
completed successfully but the
subsequent POSTs have failed.
SSA PCI adapter open firmware
about to exit (no stack corruption).
SSA PCI adapter open firmware
has run unsuccessfully.
SSA PCI adapter open firmware
about to exit (with stack corruption).
Create system firmware VPD.
Create memory VPD.
Create processor card VPD.
Create operator panel VPD.
Create CEC VPD.
Create clock card VPD.
Create RIO extender card VPD.
Create system VPD.
Create RIO to PCI adapter VPD.
Action/ Possible Failing FRU
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
"Determining Location Code" on
page 105.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
"Determining Location Code" on
page 105.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
"Determining Location Code" on
page 105.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
"Determining Location Code" on
page 105.
If a location code is associated with
the checkpoint, replace the adapter
identified by the location code. See
"Determining Location Code" on
page 105.
Replace the system board,
Location: P1. See the note on page
84.
Replace the memory. See the note
on page 84.
Go to "MAP 1540: Minimum
Configuration" on page 57.
Replace the operator panel,
Location: L1. See "Operator Panel
Replacement" on page 105.
See the note on page 84.
See the note on page 84.
Replace the system planar,
Location: P1. See the note on page
84.
Replace the system planar,
Location: P1. See the note on page
84.
Replace the system planar,
Location: P1. See the note on page
84.