Table of Contents
Advertisement
3. Push the card into the system unit until you feel it stop. The card should be far
enough into the system unit so that the camming latches engage.
4. Close the camming latches to secure the card into the connector.
Attention:
camming latches at the same time.
5. Replace the processor and memory riser card cover as described in "Replacing
Processor and Memory Riser Card Cover" on page 315.
6. Replace the system unit covers as described in "Replacing Covers" on page 314.
Memory and Processor Card CEC Assembly
Removal
1. Remove the memory and processor cards, as described in "Memory Riser Card and
Processor Card" on page 342.
2. Remove the eight screws that hold the CEC (central electronics complex) assembly
in the system.
3. Pull the CEC assembly out of the system.
Replacement
Replace in reverse order.
344
Service Guide
To prevent damage to the card and to the card connectors, close both
Advertisement
Table of Contents
