IBM F80 Service Manual page 155

Table 6. Firmware Error Codes (continued)
Error Code Description
2B20 0022 Processor is deconfigured by the
system.
2B2x xx31 Processor is failing POST
2B20 0031 Processor is failing POST or is
manually disabled.
2B20 0042 Unknown processor card
2BA00000 Service processor POST failure
2BA0 0012 Service processor reports self test
failure
2BA0 0013 Service processor reports bad
NVRAM CRC
2BA0 0017 Service processor reports bad or low
battery.
2BA0 0041 Service processor VPD is corrupted.
Action/ Possible Failing FRU
1. Replace the processor card,
Location: P1-C1
2. System board, Location: P1
Replace the processor card.
Location: P1-C1
1. If the processor is not enabled,
use the service processor menus
to enable the processor. Then
reboot the system.
2. If the processor is failing POST,
replace the processor card.
Location: P1-C1.
Remove the unknown processor
card. Location: P1-C1.
Replace the system board. (See note
3 on page 41.) Location: P1
Replace the system board. (See note
3 on page 41.) Location: P1
If problem persists, replace the
system board. (See note 3 on page
41.) Location: P1
1. Replace the battery.
2. Replace the system board. (See
note 3 on page 41.) Location: P1
Replace the system board. (See note
3 on page 41.) Location: P1
Chapter 5. Error Code to FRU Index
137