Table of Contents
Advertisement
Table 2. Firmware Checkpoints (continued)
Checkpoint
E440
E441
E442
E443
E500
98
Service Guide
Description
Validate NVRAM, initialize partitions
as needed
Generate /options node NVRAM
configuration variable properties
Validate NVRAM partitions
Generate NVRAM configuration
variable dictionary words
Configure remote I/O subsystem
Action/ Possible Failing FRU
1. Verify that the system firmware
levels are at the current release
levels, update as necessary.
2. Replace system board (location:
P1) if problem persists.
See the note on page 84.
1. Verify that the system firmware
levels are at the current release
levels, update as necessary.
2. Replace system board (location:
P1) if problem persists.
See the note on page 84.
1. Verify that the system firmware
levels are at the current release
levels, update as necessary.
2. Replace system board (location:
P1) if problem persists.
See the note on page 84.
Suspect a system firmware problem
if problem persists. Verify that the
system firmware is at current
release level. Update back-level
system firmware if necessary.
See the note on page 84.
1. Configure I/O subsystem.
2. The appearance of this code
indicates that the I/O subsystem
configuration has started or
progressed to the point where
the code can be displayed.
See the note on page 84.
Advertisement
Table of Contents
