Table of Contents
Advertisement
Table 7. Service Processor Error Codes (continued)
Error Code
Description
4068 00A6
Other bus processor runtime
diagnostics detected no usable
memory
4068 00A7
Other bus processor diagnostics
detected hardware problem
4068 00B0
Other bus processor runtime
diagnostics detected bus controller
lock-unlock failure
4068 00B1
Other bus processor runtime
diagnostics detected bus controller
failure
4068 00B7
Other bus processor runtime
diagnostics detected insufficient
hardware resources to continue IPL
4068 0100
Other bus processor runtime
diagnostics detected memory riser
card fault
4068 0101
Other bus processor runtime
diagnostics detected memory DIMM
fault
4068 0102
Other bus processor runtime
diagnostics detected memory DIMM
fault
4068 0103
Other bus processor runtime
diagnostics detected memory DIMM
fault
4068 0104
Other bus processor runtime
diagnostics detected memory DIMM
fault
Action/ Possible Failing FRU
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 268 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2
Memory DIMM Location: P1-M2.15
Memory DIMM Location: P1-M2.1
Memory DIMM Location: P1-M2.16
Memory DIMM Location: P1-M2.2
Chapter 5. Error Code to FRU Index
149
Advertisement
Table of Contents
