System Firmware Update Messages; Common Firmware Error Codes - IBM F80 Service Manual

Table 7. Service Processor Error Codes (continued)
Error Code
4B2F 300D
4B2F 300E
4B2F 301F
4B2F 303A

System Firmware Update Messages

Table 8. System Firmware Update Messages
Error Code
A1FD 0000
A1FD 0001
A1FD 0002
A1FD 0003
A1FD 0004

Common Firmware Error Codes

Attention:
page 106. If you replace FRUs or perform an action and the problem is still not
corrected, go to "MAP 1540: Minimum Configuration" on page 57 unless otherwise
indicated in the tables.
If you replace FRUs or perform an action and the problem is corrected, go to "MAP
410: Repair Checkout" in RS/6000 and Eserver pSeries Diagnostic Information for
Multiple Bus Systems.
Note: Do not shut down the system if the FRU was replaced by hot swap.
Table 9. Common Firmware Error Codes
Error Code
B006 1403
Description
Processor system and error code
generation/logging detected 512MB
(stacked) DIMM fault
Processor system and error code
generation/logging detected 512MB
(unstacked) DIMM fault
Processor system and error code
generation/logging detected 128MB
DIMM fault
Processor system and error code
generation/logging detected 1GB
DIMM fault
Description
Service processor flash recovery
mode entered
Service processor flash recovery
Service processor flash recovery
Service processor flash recovery
Service processor flash recovery
Follow the procedure defined in the "Checkpoint and Error Code Index" on
Description
Missing service processor resource
Action/ Possible Failing FRU
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
Memory DIMM, Location: P1-M1.n or
P1-M2.n or P1-C1-Mn
Action/ Possible Failing FRU
Attention message
Insert Diskette #1
Insert Diskette #2
Insert Diskette #3
Insert Diskette #4
Action/ Possible Failing FRU
1. Update system firmware
2. System board, Location: P1
Chapter 5. Error Code to FRU Index
239