Table of Contents
Advertisement
Table 7. Service Processor Error Codes (continued)
Error Code
406A 0332
406A 033D
406A 03FF
406A 3101
406A 3281
406A 3284
406A 3285
406A 3286
406B 0001
406B 0003
406B 0009
406B 00A0
406B 00A1
406B 00A2
406B 00A3
406B 00A4
406B 00A5
162
Service Guide
Description
Self tests detected memory DIMM
fault
Self tests detected memory DIMM
fault
Self tests detected memory failure on
processor card that cannot be
automatically isolated.
Self tests detected RIO port 0 fault
Self tests detected RIO port 0 fault
Self tests detected PCI controller
PHB0 fault
Self tests detected PCI controller
PHB1 fault
Self tests detected PCI controller
PHB2 fault
Wire tests detected system board
fault
Wire tests detected processor fault
Wire tests detected memory fault
Wire tests detected service processor
firmware fault
Wire tests detected system firmware
fault
Wire tests detected service processor
firmware (PRD) fault
Wire tests detected memory plugging
fault
Wire tests detected application
caused fault
Wire tests detected invalid system
configuration
Action/ Possible Failing FRU
Memory DIMM Location: P1-C1-M4
Memory DIMM Location: P1-C1-M4
x2
Go to "MAP 1540: Minimum
Configuration" on page 57, and run
minimum configuration for further
isolation.
1. RIO port 0, Location: P1-C1
2. System board, Location: P1
1. RIO port 0, Location: P1-C1
2. System board, Location: P1
Replace the system board. Location:
P1 (See note 3 on page 41.)
Replace the system board. Location:
P1 (See note 3 on page 41.)
Replace the system board. Location:
P1 (See note 3 on page 41.)
Replace the system board. Location:
P1 (See note 3 on page 41.)
All processors, Location: P1-C1
Go to "MAP 1540: Minimum
Configuration" on page 57.
Update system firmware
1. Check for AIX updates
2. Check for system firmware
updates
Update system firmware
Go to "MAP 1540: Minimum
Configuration" on page 57.
Application software
Verify that system components are
supported and properly installed
Advertisement
Table of Contents
