Table of Contents
Advertisement
LED
Green (Top)
Amber (Bottom)
MAP 2010: SSA Hot-Swap Disk Drive–Start
This MAP is the entry point to the MAPs for the SSA hot-swap disk drive. If you are not
familiar with these MAPs, read "Using SSA MAPs" on page 75.
You might have been sent here because:
v The system problem determination procedures sent you here.
v Action from an SRN list sent you here.
v A problem occurred during the installation of an SSA hot-swap disk drive module.
v Another MAP sent you here.
v A customer observed a problem that was not detected by the system
problem-determination procedures.
Step 2010-1
Have you been sent to this MAP from the Configuration Verification service aid?
NO
YES
Step 2010-2
One of the following conditions exists. Take the action described.
1. You have an hdisk that has no associated pdisk.
a. Issue the system cfgmgr command.
b. Retry the Configuration Verification service aid.
c. If the problem remains, a software error has probably occurred. Call your
2. You have a pdisk that has no associated hdisk.
a. Run diagnostics (using system verification mode) on the pdisk.
b. If you get an SRN, go to Table 12 on page 429 and follow the actions described.
Status LEDs
Status
Flashing
Off
On Steady
Slow Blink
On Steady
Slow Blink
Off
Go to "Step 2010-3" on page 78.
Go to "Step 2010-2."
support center for assistance.
Definition
Drive activity
Drive not spinning and no activity
Drive spinning and no activity
One link not active
Service action
Concurrent maintenance
Both links are bad
Identify only
Power good
Chapter 3. Maintenance Analysis Procedures
77
Advertisement
Table of Contents
