6C - 8 ENGINE FUEL
FUEL FILTER CARTRIDGE
REMOVAL
•
Remove the cartridge using a filter wrench.
Filter wrench: 5-8840-0253-0 (J-22700)
INSTALLATION
•
Clean the cartridge mounting surface of filter body so
that the cartridge can be securely.
Apply engine oil thinly to new cartridge O-ring.
•
To facilitate bleeding, fill the new cartridge with light oil.
•
Tighten the cartridge until O-ring comes in contact with
the sealing, taking care not to spill the light oil.
•
Retighten 1/3~ 2/3 using a filter wrench.
Filter wrench: 5-8840-0253-0 (J-22700)
6C-7-1.tif
Bleeding
•
Operate priming pump to send the air in the fuel
system to the injection pump.
•
Loosen injection pump bleeding plug, and operate the
priming pump until no bubble is made.
•
Tighten the bleeding plug.
•
Start the engine, and if it is not started in 10 seconds
or less, repeat the bleeding steps.
•
Make sure of no fuel leakage, and tighten the priming
pump.
6C-7-2.tif
Draining
•
When the water in the sedimentor reaches the
specified volume, warning light is actuated.
In this case, follow the draining steps below.
•
Set a vinyl hose over the drain plug.
•
Loosen the drain plug.
•
To drain the water, operate the priming pump several
times.
•
After draining, tighten the drain plug.
•
Operate the priming pump several times to check for
fuel leakage.
•
Check and see the warning light is off.