Installation; Interface Self-Test - Black Box PC124C Installation Manual

To install the Laser Card, follow these simple steps. Consult the Quick Start Guide
in Chapter 3 for more information.
The Laser Card is static sensitive. Follow the static sensitivity
instructions in the front of this manual when handling the card.
1. Power ON the printer and perform a printer self-test as described in the
printer's manual. Do not continue until the printer passes the self-test.
2. Power OFF the printer and remove all cables.
3. Locate an available EIO slot. Using the screwdriver, remove the bracket
covering it.
4. Insert the Laser Card and tighten the thumb screws.
5. Attach the twinax or coax adapter cable. Do NOT attach the host cable(s) to
the adapter yet.
6. Re-attach the power cord and other printer cables.

4.1 Interface Self-Test

Verify proper installation of the interface by performing an interface self-test. The
self-test printout contains the current software version, memory condition (RAM
and ROM) and the current setup selections for reference. Follow the steps below
to print the self-test.
1. Make sure the proper (twinax or coax) 9-pin adapter cable is securely
attached to the interface.
2. Power ON the printer and wait for it to go into "Ready" mode.
3. Press Menu repeatedly until TWINAX/COAX CARD is displayed.
4. Press Item - to display "98=TEST MENU"
5. Press Value - to display "98=PRINT SETUP".
6. Press Select. An asterisk will appear: "98=PRINT SETUP*".
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS

4. Installation

WARNING
21