Formatting The Page; Paper Size - Black Box PC124C Installation Manual

To select a resident scalable font with a specific point size, use the following
format:
¬F5687,14
where ¬ is a "logical not" or alternately the caret "^" symbol, F indicates a resident
scalable font-change, 5687 is the font number, and 14 is the desired point size.
The resident scalable font numbers are located in Appendix D.
All text following the command will be printed in the new font until you specify
another font change command.
The host may send the original font code to the printer at the beginning
of each page. If this happens, you may need to put a font-change
command at the beginning of each page of your document.
If the font-change command changes the pitch, the host may continue to
format each line according to the original font ID pitch. For Text
Management/38 and other word-processing programs, you may not be able to
specify more than one font ID per line.

6.5 Formatting the Page

The printer prints up to 66 lines at 6.25 LPI (the line spacing is compressed slightly
to fit). The System/36 only allows 65 lines per page. If you get one or two lines at
the top of the next page, it's usually because you have formatted more lines per
page than can be printed.

6.6 Paper Size

Configure the printer's setup to the paper size you use most. The MPP and font
must match the paper size exactly to work correctly. The interface only recognizes
these paper sizes:
Letter Paper
A4 Paper
Legal Paper
Executive Paper 7.25 x 10.5 in. (184.2 x 266.7 mm)
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
8.5 x 11 in. (215.9 x 279.4 mm)
8.27 x 11.69 in. (210 x 297 mm)
8.5 x 14 in. (215.9 x 355.6 mm)
NOTE
49