Black Box PC124C Installation Manual page 99

LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
VALUE
XXYY
Host download commands use the CPT beginning delimiter characters
as well. The new character(s) replace the &% in front of the Z.
If you do not select an ending delimiter with Command 39, the delimiter
selected with this command will be used as the default ending delimiter.
The default beginning delimiter will no longer be active if you use this
command to change it.
One delimiter character can be specified instead of two by entering the
hex code for the character followed by two zeros (e.g., &%Z40,2500
selects & as the delimiter).
A hex code that starts with 00 is invalid.
Example: &%Z40,253F
characters (the ASCII hex value of % is 25; the ASCII hex value of ? is 3F).
COMMAND 41: COMMAND ID CHARACTER
Specifies the character that is used for the command identifier that follows the
delimiter characters.
VALUE
00
ZZ
The character selected must be a hex value (L, P, or U).
Example: &%Z41,59 specifies "Y" as the command ID character
COMMAND 42: START AND STOP EBCDIC HEX DUMP
After receiving a start command, the coax interface, starting with the next buffer
received, sends all host data directly to the printer as hexadecimal printing until
the printer is powered off.
98
DESCRIPTION
XX is the ASCII hexadecimal value of the first character and YY
is the ASCII hexadecimal value of the second character.
Specifies the %? characters as the beginning delimiter
DESCRIPTION
Deletes the previously selected character
ZZ is the ASCII hex value of the command ID character
NOTES
NOTE