Black Box PC124C Installation Manual page 98

VALUE
0
*1
If true LPI is selected, the user needs to adjust the document formats to
allow for the reduced number of lines that can be printed per page, or
the extra lines may print onto another sheet of paper.
Example: &%Z38,1 specifies that vertical spacing prints using true 6 and 8 LPI.
COMMAND 39: CPT ENDING DELIMITER CHARACTERS
Specifies the two characters to be used for the ending delimiter characters or
Command Pass-Thru.
VALUE
XXYY
If an ending delimiter is not selected with this command, the delimited
selected with Command 40 will be used as a default.
The default delimiter will no longer be active if the command is used to
change it. If Command 39 and Command 40 are both entered, Command
39 must be sent after Command 40 to be active.
One delimiter character can be specified instead of two by entering the
hex code for the character followed by two zeros (e.g., &%Z39,2500
selects & as the delimiter).
A hex code that starts with 00 is invalid.
Example: &%Z39,253F specifies the %? characters as the alternate ending
delimiter characters (the ASCII hex code for % is 25; the ASCII hex code for ? is
3F).
COMMAND 40: CPT START DELIMITER CHARACTERS
Specifies the two characters to be used for the beginning delimiter characters for
Command Pass-Thru.
*Factory-default setting.
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
DESCRIPTION
Compress the vertical LPI spacing
Print using true 6 and 8 LPI spacing
DESCRIPTION
XX is the ASCII hexadecimal value of the first character and YY
is the ASCII hexadecimal value of the second character.
NOTE
NOTES
97