Black Box PC124C Installation Manual page 106

VALUE
XX
YY
Previously stored substitutions are automatically changed to the new
selection when the same hex location is specified in the EBCDIC table.
Previously stored substitutions are canceled if an ASCII hex sequence
of 00 is specified.
Command Z99,0 must be used to store the substitutions in permanent
memory for them to be effective when the printer is next turned on.
The active EBCDIC (SCS/LU1) translation table prints out at the end of
the interface self-test summary.
Example: &%Z70,7B,40/Z99,0 prints a 40 ASCII hex (a @ symbol) when the
interface receives an EBCDIC 7B (a # symbol). The command is followed by a
command Z99,0, which stores the active setup selections in permanent memory.
COMMAND 71: OVERWRITE DSC (LU3) TRANSLATION TABLE
Custom substitutions defined by this command, and stored in the permanent
memory, are overwritten into the DSC (LU3) to ASCII translation table.
This command functions similarly to Command 70 except the
substitutions are applicable to the DSC (LU3) translation table. Refer to
the Command 70 instructions.
The active DSC (LU3) translation table prints out at the end of the
interface self-test summary.
COMMAND 98: RESTORE DEFAULTS OR PRINT CONFIGURATION
Restores the factory default configuration selections, prints out a copy of the active
configuration selections, or restores the permanent memory selections to the
active setup status.
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
DESCRIPTION
The EBCDIC character to be changed (in hex)
The substitute ASCII character for the EBCDIC character above
NOTES
NOTES
105