Custom User Strings; Scs Mode Transparent Data - Black Box PC124C Installation Manual

This is a &%1B45&%bold&%1B46&% word.
to print on the printer as:
This is a bold word.
Only numbers or the upper-case letters A through F are allowed.
Errors in the Command Pass-Thru sequence will cause the interface to
ignore the command and resume printing at the point the error
occurred.
Command Pass-Thru may change the horizontal spacing. (Since the
word-processing software sees printer commands as text, lines with
comands in them may be shorter than other lines then you print the
document.)

1.2 Custom User Strings

Host download command 55 allows you to define up to six (0 through 5) custom
user strings. A user string can be a font ID, a form feed, or another printer
command that is frequently used. See Command 55 in Section 9.2.
After the custom user string is defined, the string is activated by placing the
delimiter (&% or the beginning delimiter defined with command 40), a capital
letter U, and the number of the desired custom user string into the text of a
document.
For example, use command 55 to define user string number 3 to send a form
feed as follows (FF = 0C in hex):
&%Z55,3(0C)
Then, to send a form feed at the end of a print job, enter the following at the
end of the document:
&%U3
Print the document, and the interface will send the 0C, or form-feed, command
to the printer when it encounters the &%U3 code.

11.3 SCS Mode Transparent Data

SCS transparent mode (SCS TRN code 35) provides a method for transparent data
transmission when operating in LU1 mode. To use this method, you must be
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
NOTES
113