By changing the width parameter, you can determine the width of the module
and the thickness of the bars and spaces.
Width parameters can range from 1 to 9.
To determine the total length of the bar code, simply multiply the module
length (found in the table on the following page) with the number of bar-code
characters.
Example: Using Code 3 of 9, you want to bar-code the word "PRINTERS." Assume
the interface also generates a check digit and the start/stop characters. Setting the
width parameter to 2 will yield a total bar-code length of approximately 4 cm or
about 1.6 inches.
Number of characters: 11 (8 letters (PRINTERS) + 2 start/stop characters + 1
check digit)
Module width (from Table E-1) 3.6 mm (0.14 inches) Calculation: 11 x 3.6
mm = 39.6 mm = 3.96 cm; or 11 x .14 in = 1.54 inches
LASER CARDS FOR HP 4000 TWINAX AND COAX PRINTERS
The table gives rounded values only.
NOTE
137