Table of Contents
Advertisement
confirm.
Set Smoothing
To enable smooth-cutting function.
Cut
This function aims to make connections smoother and is
suggested to be disabled when cutting small-sized images or
characters
Over Cut
To generate an overcut to facilitate weeding.
This function mainly applies to thick materials, aiming to
sharpen corners and ensure perfect connections.
Set Tangential
To enable the emulated tangential-cutting mode for thicker
Mode
media types and small letter cuts.
Note: while the Offset value setting at 0.000 mm, "Set
Tangential Mode" will automatically be disabled.
Pouncing
To make perforated patterns.
* In order to use this function, Pouncing tool must be installed.
* Before start pouncing, place pouncing strip on top of the
cutting pad to protect the cutting pad.
* Set the value as 0 mm to disable the pouncing mode.
* Pouncing tool is an optional item.
Panel Setup
Accept setup command:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Restore Default To turn all parameters of the menu items to factory-default
settings.
Auto Unrolled
To avoid paper jam and motor crash by automatically unroll
Media
media (50cm and up) before cutting while enabled. .
* Auto-unroll only affects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
Vacuum
To help improve tracking and cutting accuracy by turning on
the fans. If you turn off the vacuum system, the fans
will remain inactive during cutting or plotting.
First Back to
To enable the carriage back to the previous origin; when
Origin
"Enable" is selected
pressed, the carriage will go back to the previous origin while
the selection of "Disable" will not allow the carriage to do so.
AAS Offset
To set or modify AAS offset value.
You can refer to "5.3 Printer Test" for more details.
Paper Saving
To save media by four different modes:
Mode
1. Length expanded mode
3. Both expanded mode
Set
To build up the communication between host computer and
cutter.
Communication
Baud Rate is to determine the speed of data transmission.
Data Bits refers to the size of one block of data.
Parity is used to check if data was revived correctly or not.
9600, n, 7, 1, p
9600, o, 7, 1, p
9600, e, 7, 1, p
The Control Panel
[ MISC ]
and the
button Online/Offline has been
2. Width expanded mode
4. Both unexpanded mode
9600pbs, 7 Bits with NO Parity
9600pbs, 7 Bits with ODD Parity
9600pbs, 7 Bits with EVEN Parity
3-7
ValueCut User Manual
Enable
0.00mm-1.00mm
0.00mm
0.05mm/per step
Enable
0~200mm
0mm
Enable
Enable
Enable
Enable
Disable
Length
expanded
mode
Hide quick links:
Advertisement
Table of Contents
