MUTOH ValueCut Series User Manual page 16

Step 5
Insert the roll holder support with the screws into the holes of the stand, and then tighten them
up as shown in
Figure 2-4
different holes.
Step 6
Place two roll holders into the holes in the roll holder support. (Figure 2-5); Push the roll holder
to the left until it is correctly positioned and then to the right to allow successful installation.
Roll holders
Installation
. You could decide roll holder support's position by inserting into
Figure 2-4
Figure 2-5
2-4
ValueCut User Manual
3 screws
Roll holder
support
Roll holder support