MUTOH ValueCut Series User Manual page 66

2. AAS II_X_Y_Offset_Caberation_600_600 .eps (Default setting, it is recommended
for testing)
Print out the testing graphic. ( Please use high precision printer)
Load the graphic to ValueCut and sent the file to test the cutting job
If there are any adjustments to be made, you can change the offset value by
following the steps:
Measure the offset values from the printed line and the actual cutting line.
Enter the AAS Offset under MISC function for the values you just measured,
then press Enter
Test the cutting again
AAS II offset X and Y value is defined as following:
Accu-Aligning System
Horizontal line is defined as X and vertical is defined as Y (when facing the
cutting plotter)
When the actual cutting line and the printed line need to be changed
towards the direction of origin mark, then simply add the negative value of
the offset. If the direction is from the opposite of the origin mark, then enter
positive values for the offset (see the following figures). This method applies
to both X and Y axes.
5-6
ValueCut User Manual