MUTOH ValueCut Series User Manual page 41

Up Speed To set or modify tool up speed at horizontal moving.
Cutting Quality To set or modify cutting quality.
While cutting small letter, set as "Small letter".
While cutting in high speed, set as "Draft".
For normal operation, set as "Normal".
Square Cut To perform a cutting test at present blade position.
For more information, please refer to "4.3 Adjusting the
Cutting Force and Offset" to adjust blade force and cutting
speed.
To repeat AAS jobs automatically without having to operate
Repeat AAS
on the computer side.
Job
Please be noted that this feature is mainly applied to the
Single paper mode; please ensure a new piece of material
you wish to apply this feature on is loaded and the origin
repositioned to the first registration mark before starting.
When the first AAS job repeat completes, the user will be
offered the choice of "Repeat AAS Job Again", please
press "Online/Offline" to return to the main menu.
Repeat Last Recut:
Plot To repeat the last job without re-sending the data.
Copy:
* 1mm gap will be auto-generated between 2 copies).
* If the media length is not enough to continue, it will show
below message on LCM:
* If both functions are enabled at the same time, the cutter will
perform the last setting only.
Pattern Setting To provide two patterns for cut test
Note: It is recommended to select "Cross" if you are working
on thick pieces of materials.
Ratio Setting To adjust the size of the pattern
Blade Length Please see 2.5 Automatic Blade Length Adjustment for further
Adjust details.
To clear up buffer memory.
Save To save pattern(s) of cutting parameters for later use.
Parameter There are 4 sets of parameters saved in the panel. Use Page
Up and Page Down keys to select the set of parameters you
wish to adjust, press "Enter" to confirm (the number shown on
the upper left corner will change accordingly). Each set of
parameters includes Speed, Force, Offset, Up Speed and
Quality though the latter two will not be displayed in this
section. To adjust or check individual parameters, go back to
the responding keys on the panel and press "Enter" to
The Control Panel
[ CUT TEST ]
To copy the last job without re-sending the data.
O u t O f S p a c e
o f C o p i e s f
[ DATA CLEAR ]
[ TOOL SELECT ]
; #
i n i s h e d
3-6
ValueCut User Manual
3~153cm/sec; 72cm/sec
3cm/sec per step
Draft, Fair, Normal
Normal, Fine,
Small Letter
1~99;
1 per step
1~99;
1 per step
"Arrow" and
"Arrow"
"Cross" patterns
100%, 200%, 100%
300%, 400%
0.00mm-5.00mm 0.00mm
Patterns1~4 Pattern 1