MUTOH ValueCut Series User Manual page 39

Offline For System Setup
[TOOL SELECT ]
[ MISC ]
The Control Panel
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Save parameter
Select: OK:ENTER
Restore default
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
Auto Unrolled Media
Select: OK:ENTER
Scale Width
Select: OK:ENTER
Scale Length
Select: OK:ENTER
Select Unit
Select: OK:ENTER
Select Language
Select: OK:ENTER
Firmware： x.x.xx
FPGA：Vx.x mm/dd/yy
Set Communication
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
AAS Offset
Select: OK:ENTER
First back to origin
Select: OK:ENTER
Vacuum
Select: OK:ENTER
use to select from 1S to 4S; [ENTER] to adjust the
parameters
Pouncing:0-200mm with an
increment of 1mm
OverCut:0.00-1.00mm with an
increment of 0.05mm
Metric (cm/gf) or English
measurement (inch/oz)
English
Both Expanded Mode、Length Expanded Mode、
Width Expanded Mode、Both Unexpanded Mode
Enable, Disable
3-4
ValueCut User Manual