MUTOH ValueCut Series User Manual page 57

Note:
The ValueCut series print driver cannot store more than 16 pen colors or different cutter
parameter settings per file.
Speed (Pen Page) [DEFAULT SETTING: 72cm/sec]
The speed slider controls the cutter's cutting speed during operation with a range setting from 3 – 153cm/sec. The
ValueCut series maximum cutting speed is 153 cm (60 inches) per second.
Force (Pen Page) [DEFAULT SETTING: 80g]
The force slider controls the cutting force during operation with a range setting from 5 – 600g.
Offset (Pen Page) [DEFAULT SETTING: 0.25mm]
The offset slider controls the blade offset depending on the blade you used.
Die Cut (Pen Page)
The Die Cut function can allow you to cut through the backing of the material. You can only use the first 8 pen for
this function. If you choose Pen No.1 and click the Die Cut function, the Pen No.9 will become Pen No.1* for setting
different parameter for the same cutting line. (Figure 4-24)
Operation
Figure 4-21
4-14
ValueCut User Manual