Ram Clear Mode (When Using The Kb-80-Qm Optional Keyboard) - TEC B-450 SERIES User Manual

6. DIAG. TEST OPERATION

6.8 RAM CLEAR MODE (When using the KB-80-QM Optional Keyboard)

In RAM clear mode, various data written on the EEP-ROM can be initialized. There are two clear functions;
Maintenance counter clear and parameter clear in the parameter setting mode.
referring to the following table specify and clear or initialize the data.
RAM Clear Mode Table
Mode Name
NO RAM CLEAR
MAINTE. COUNTER
CLEAR
PARAMETER CLEAR
6.8 RAM CLEAR MODE (When using the KB-80-QM Optional Keyboard)
If you enter the RAM clear mode by mistake, specify this mode to
escape from the RAM clear mode without executing RAM clear.
After replacing the print head, cutter module, ribbon feed/rewind
motor, and CPU PC Board, clear the maintenance counter. The
following data will be cleared to zero. Confirmation can be made
through the maintenance counter procedure in self test mode.
(See NOTE 1 and 2.)
Item
Paper distance covered
Print distance
Cut count
Ribbon Motor Drive time
RS-232C hardware error count
System error count
Momentary power failure count
This clear should be employed when initializing the following
parameters to the settings before shipment. Confirmation can be
made through the automatic diagnostic procedure in self test mode.
(See NOTE 1 and 2.)
Feed length fine adjustment (PC)
Cut/strip position fine adjustment (PC)
Back feed length fine adjustment (PC)
Print tone fine adjustment (Thermal Transfer) (PC)
Print tone fine adjustment (Thermal Direct) (PC)
Ribbon motor dirve voltage Fine Adjustment (PC)
Feed length fine adjustment (KEY)
Cut/strip position fine adjustment (KEY)
Back feed length fine adjustment (KEY)
Print tone fine adjustment (Thermal Transfer) (KEY)
Print tone fine adjustment (Thermal Direct) (KEY)
Ribbon motor Drive voltage fine adjustment (KEY)
6-49
Function
Initial Value
0 times
0 hours
0 times
0 times
0 times
Item
EO18-33003A
After
0 km
0 km
Initial Value
0 mm
0 mm
0mm
0 step
0 step
0 step
0 mm
0 mm
0 mm
0 step
0 step
0 step