Sensor Setting Mode (When Using The Operation Panel) - TEC B-450 SERIES Maintenance Manual

6. DIAG. TEST OPERATION

6.6 SENSOR SETTING MODE (When using the operation panel)

Power OFF
DIPSW
6
OFF
Power ON
Power
Power
Power
Power
Power
Power
Power OFF
: ON
: OFF
: BLINK
7 8
ON ON
[FEED]
Online Error
[PAUSE]
Online Error
[FEED]
Online Error
[PAUSE]
Online Error
[FEED]
Online Error
[PAUSE]
Online Error
6.6 SENSOR SETTING MODE (When using the operation panel)
(1) Turn the power OFF.
(2) Set the DIP switches to enter the manual threshold
setting mode.
(3) Turn the power ON while pressing and holding the
[FEED] key.
(4) The printer enters the sensor setting mode.
(5) Adjust the black mark sensor.
Set the tag paper so that the sensor can detect the
white part of the paper.
(6) Press and hold the [PAUSE] key for 3 seconds or
more.
(7) The power LED blinks when the black mark sensor
adjustment is completed.
(8) Press the [FEED] key.
(9) Adjust the feed gap sensor.
Remove a few labels from the label roll and set it so
that the sensor can detect the backing paper.
(10)Press and hold the [PAUSE] key for 3 seconds or
more.
(11) The online LED blinks when the feed gap sensor
adjustment is completed.
(12)Press the [FEED] key.
(13)Enter the sensor settings. (Enter the paper end.)
Remove the paper from the printer.
(14)Press and hold the [PAUSE] key for 3 seconds or
more.
(15)The power LED and online LED blinks when the two
sensors entry is completed.
(16)Turn the power OFF.
(17)Set the DIP switches to original position.
6-47
EO18-33003A