Feed Length Fine Adjustment - TEC B-450 SERIES User Manual

6. DIAG. TEST OPERATION
6.3.1

Feed Length Fine Adjustment

< 1
< 2
F E
Press the [C] key.
S E
Y E
Press the [ENTER] key or [C] key.
NOTES: 1. Holding the [ ↓ ] key or [ ↑ ] key down for more than 0.5 seconds enables a fast forward.
2. Max. fine adjustment ± 10.0 mm (B-452-TS)/ ± 50.0 mm (B-452-HS) = Key fine
adjustment value ( ± 10.0 mm) + PC fine adjustment value (B-450-TS: ± 10.0 mm/
B452-HS: ± 50.0 mm)
When the value reaches the maximum, the value remains unchanged even if the
subsequent fine adjustment is performed.
3. A change feed value is stored in keyboard memory by pressing the [ → ] key.
Power off
Turn on the power while
holding down the [SHIFT]
key.
>
D I A G .
Press the [↓]key.
>
P A R A M E T E R
Press the [→] key.
E D A D J . + 0 . 0 m m
Press the [↓] or
[↑] key to adjust
the feed length.
(See NOTE 1.)
Press the [ENTER] key.
T T O P R I N T E R
S : [ E N T ] N O : [
S E T
↓
[ ] key:
↑
[ ] key:
Press the [→] key.
?
Continued on Section 6.3.2
C ]
Cut/strip position fine adjustment.
6-13
EO18-33003A
6.3 PARAMETER SETTING MODE
↓
Pressing the [ ] key one time is a
-0.5 mm change, up to -10.0 mm
(B-452-TS model)/-50.0 mm (B-452-
HS model). (See NOTE 2.)
↑
Pressing the [ ] key one time is a
+0.5 mm change, up to +10.0 mm
(B-452-TS model)/+50.0 mm (B-
452-HS model). (See NOTE 2.)