Self Test Mode (When Using The Kb-80-Qm Optional Keyboard) - TEC B-450 SERIES User Manual

6. DIAG. TEST OPERATION

6.2 SELF TEST MODE (When using the KB-80-QM Optional Keyboard)

In self test mode the printer status is printed in two types of sample print.
6.2.1 Maintenance Counter and Automatic Diagnostic Printings
Maintenance Counter Printing
The data from (1) to (35) on a sample print A is printed. This data is the printer status and the value
set in the parameter setting mode.
Automatic Diagnostic Printing
The data from (1) to (12) on a sample print B is printed.
< 1
R I
R I
NOTES: 1. If the maintenance counter printing results in an error, the printer will display the error
message and stop printing. The error status can be cleared by the [PAUSE] key,
however, the display will return to the initial display "<1> DIAGNOSTIC Software
Version No.". Printing is not automatically resumed after the error is cleared.
2. Both label and tag paper can be used for printing.
Power off
Turn on the power while
holding down the [SHIFT]
key.
>
D I A G .
V 1 . 0
Press the [→] key.
B B O N U S E
Press the [↓] key or [↑] key.
B B O N N O N E
Press the [ENTER] key.
The result of the self test
is printed. After printing,
the initial display will be
shown.
RIBBON USE: In case of thermal transfer print.
RIBBON NONE: In case of thermal direct print.
NOTE: For the B-452-HS model,
this parameter is fixed to RIBBON USE.
[
The printer is checking or printing
the status
6-3
EO18-33003A
(Revision Date: Aug. 8, 2000)
6.2 SELF TEST MODE
]