Command Reference - Xconfiguration - Cisco TelePresence Administrator's Manual

Command reference — xConfiguration
The xConfiguration group of commands are used to set and change individual items of configuration.
Each command is made up of a main element followed by one or more sub-elements.
To obtain information about existing configuration, type:
xConfiguration to return all current configuration settings
n
xConfiguration <element> to return configuration for that element and all its sub-elements
n
xConfiguration <element> <subelement> to return configuration for that sub-element
n
To obtain information about using each of the xConfiguration commands, type:
xConfiguration ? to return a list of all elements available under the xConfiguration command
n
xConfiguration ?? to return a list of all elements available under the xConfiguration command,
n
along with the valuespace, description and default values for each element
xConfiguration <element> ? to return all available sub-elements and their valuespace, description
n
and default values
xConfiguration <element> <sub-element> ? to return all available sub-elements and their
n
valuespace, description and default values
To set a configuration item, type the command as shown. The valid values for each command are indicated
in the angle brackets following each command, using the following notation:
Format Meaning
<0..63> Indicates an integer value is required. The numbers indicate the minimum and maximum
value. In this example the value must be in the range 0 to 63.
<S: 7,15> An S indicates a string value, to be enclosed in quotation marks, is required. The numbers
indicate the minimum and maximum number of characters for the string. In this example the
string must be between 7 and 15 characters long.
<Off/Direct/Indirect> Lists the set of valid values. Do not enclose the value in quotation marks.
[1..50] Square brackets indicate that you can configure more than one of this particular item. Each
item is assigned an index within the range shown.
For example IP Route [1..50] Address <S: 0,39> means that up to 50 IP routes can
be specified with each route requiring an address of up to 39 characters in length.
xConfiguration commands
All of the available xConfiguration commands are listed in the table below:
Cisco VCS Administrator Guide (X7.2)
Reference material
Page 403 of 498