Cisco TelePresence Administrator's Manual page 436

Reference material
Zones LocalZone SubZones MembershipRules Rule [1..3000] State: <Enabled/Disabled>
Indicates if the membership rule is enabled or disabled. Disabled membership rules are ignored.
Default: Enabled
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 State: Enabled
Zones LocalZone SubZones MembershipRules Rule [1..3000] SubZoneName: <S: 0,50>
The subzone to which an endpoint is assigned if its address satisfies this rule.
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 SubZoneName:
"Branch Office"
Zones LocalZone SubZones MembershipRules Rule [1..3000] Subnet Address: <S: 0,39>
Specifies an IP address used (in conjunction with the prefix length) to identify this subnet.
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 Subnet Address:
"192.168.0.0"
Zones LocalZone SubZones MembershipRules Rule [1..3000] Subnet PrefixLength: <1..128>
The number of bits of the subnet address which must match for an IP address to belong in this subnet.
Default: 32
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 Subnet
PrefixLength: 32
Zones LocalZone SubZones MembershipRules Rule [1..3000] Type: <Subnet/AliasPatternMatch>
The type of address that applies to this rule.
Subnet: assigns the device if its IP address falls within the configured IP address subnet.
AliasPatternMatch: assigns the device if its alias matches the configured pattern.
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 Type: Subnet
Zones LocalZone SubZones SubZone [1..1000] Authentication Mode:
<DoNotCheckCredentials/TreatAsAuthenticated/CheckCredentials>
Controls how the VCS authenticates incoming messages from this subzone and whether they are subsequently
treated as authenticated, unauthenticated or are rejected. The behavior varies for H.323 messages, SIP
messages that originate from a local domain and SIP messages that originate from non-local domains. See the
Administrator Guide for further information.
Default: DoNotCheckCredentials
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Authentication Mode:
DoNotCheckCredentials
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if
Mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Inter
Limit: 1920
Cisco VCS Administrator Guide (X7.2) Page 436 of 498