Cisco TelePresence Administrator's Manual page 402

ID Title
55127 B2BUA
misconfiguration
55128 B2BUA
misconfiguration
55129 B2BUA
misconfiguration
55130 B2BUA
misconfiguration
55131 B2BUA
misconfiguration
55132 B2BUA
misconfiguration
55133 B2BUA
misconfiguration
55134 B2BUA
misconfiguration
55135 B2BUA
configuration
warning
Cisco VCS Administrator Guide (X7.2)
Description
Cannot start B2BUA
application because FQDN
configuration is missing
Cannot start B2BUA
application because IPv4
interface address
configuration is missing
Cannot start B2BUA
application because cluster
name configuration is missing
Missing cluster name
Invalid session refresh interval Check
Invalid call resource limit
The B2BUA session refresh
interval is smaller than the
minimum session refresh
interval
Invalid minimum session
refresh interval
A large number of OCS/Lync
trusted host devices have
been configured; this may
impact performance, or in
extreme cases it may prevent
calls from accessing enough
network resources to connect
Solution
Configure the Local host name and
Domain name on the DNS
then restart the B2BUA service
Configure the LAN 1 IPv4 address on the
IP page, and then restart the B2BUA
service
Configure the cluster name on the
Clustering page, and then
B2BUA service
Restart the service; if the problem
persists, contact your Cisco
representative
B2BUA configuration
settings) and then restart the B2BUA
service
Restart the service; if the problem
persists, contact your Cisco
representative
Check both settings on the
configuration (advanced settings) and
then restart the B2BUA service
Check B2BUA configuration
settings) and then restart the B2BUA
service
Review your network topology and try
lowering the number of trusted host
devices on the B2BUA trusted hosts
page and then restart the B2BUA service
Reference material
Severity
Warning
page, and
Warning
Warning
restart the
Warning
(advanced Warning
Warning
B2BUA Warning
(advanced Warning
Warning
Page 402 of 498